디지털 멀티미터 커패시턴스 검출 방식
1, the detection of 10pF below the small 커패시턴스 due to 10pF below the fixed 커패시터 용량 is too small, with a 멀티미터 for measurement, can only qualitatively check whyther there is a leakage, internal short circuit or breakdown phenomenon. Measurement, you can choose the multimeter resistance file, with two pens were connected to any two pins of the capacitor, the resistance value should be infinity. 만약 측정 저항 (포인터 스윙 오른쪽) is zero, then the 커패시터 누설 손상 또는 내부 고장.
2, test 10PF ~ 0.01μF 고정 커패시터 whether 충전 현상, and then judge its good or bad. 멀티미터 선택 저항 블록. Two 트랜지스터 값 are more than 100, and penetration current to be some optional 3DG6 and other models of silicon transistor composite tube. The red and black pens of the multimeter are connected to the emitter e and collector c of the composite tube. Due to the amplifying effect of the composite 트랜지스터, the 측정 커패시턴스 of the charge and discharge process to be amplified, so that the 멀티미터 포인터 스윙 진폭 증가, so as to 촉진 관찰. 그것 해야 한다 be noted that: in the test operation, 특히 in the 측정 of smaller 커패시턴스, to 반복 스위치 the 측정 커패시턴스 핀 접촉 A, B 2 포인트, in 주문 to 명확하게 see 멀티미터 포인터 스윙.
3, for more than 0.01μF 고정 커패시턴스, the 멀티미터 can be used to directly test the 커패시터 with or without 충전 프로세스 and 내부 단락 or 누설, and can be based on the magnitude of the pointer to the right of the magnitude of the 진동 of the 커패시터's 용량 is 추정.
인덕터 테스트
그만큼 멀티미터 의지 있다 배치 안에 그만큼 저항 파일, 그만큼 빨강 및 검은색 펜 아르 연결된 에 그만큼 컬러 코드 인덕터 의 어떤 리드, 더 포인터 해야 한다 스윙 에 그만큼 오른쪽 에 이 시간. 일치 에 더 크기 의 더 측정 저항 값, 캔 있다 구체적으로 분할 더 다음 셋 케이스 위해 식별:
1. 측정 저항 값 색상 코드 인덕터 IS 제로 % 2C 그것 내부 단락 실패.
2. The 크기 의 the 측정 DC 저항 값 of the 색상으로 구분된 인덕터 및 에나멜 와이어 사용 to 바람 인덕터 코일 직경, the 수 of 권선 회전 have a direct relationship, as long as the resistance value can be measured, it can be considered that the measured colour-coded inductor is normal.
